gigasept® instru AF

gigasept® instru AF is an aldehyde-free disinfectant and cleaner for medical instruments.

Our Plus

  • aldehyde-free
  • very good cleaning performance
  • broad spectrum of microbiological efficacy
  • shortened contact time in ultrasonic bath

Downloads

Fields of Application

Suitable for manual cleaning and disinfection of thermostable and thermolabile instruments of all types (excluding flexible endoscopes). Thanks to its excellent cleaning performance - especially in an ultrasonic bath - and its comprehensive microbiological efficacy, gigasept® instru AF offers all important product features for instrument reprocessing in hospitals and practices.

Instructions for use

gigasept® instru AF is a concentrate and is diluted with cold water to produce the desired application concentration.
Dosage:
depending on the degree of effectiveness 1.5 % - 4 %.
Application example:
1 litre of a 3 % working solution corresponds to 970 ml of water and 30 ml of gigasept® instru AF.
Immerse instruments to be reprocessed in the gigasept® instru AF solution immediately after use. Ensure complete covering of the surfaces, also of hollow instruments, and allow them to soak in the solution. Rinse all instruments thoroughly after cleaning, using water of at least drinking water quality, or preferably sterile distilled water or fully deionised water, to completely remove residues of the cleaning solution.
Do not exceed indicated contact times and concentrations. Please follow the reprocessing recommendations of the instrument manufacturers. National regulations may require that cleaning and disinfection are carried out in two separate process steps. Not for final disinfection ofsemicritical and critical medical devices!
Standing time:
A standing time of 7 days applies if the working solution is only used for the disinfection of previously cleaned instruments. If the working solution is used for cleaning, national regulations may limit the timespan during which the solution may be used.
Ultrasonic cleaning:
gigasept® instru AF is particularly suitable for use in ultrasonic devices. The chemical stability of the product is maintained in this process. Studies have shown that very good cleaning can be achieved with gigasept® instru AF after only a few seconds. Reference reports can be provided on request. Moreover, the stock solution should not be heated above 40 °C.

Microbiological efficacy

EfficacyConcentrationContact time
bactericidal
EN13727, EN14561, in accordance with VAH
- dirty conditions
2 % (20 ml/l)30 min.
bactericidal
EN13727, EN14561, in accordance with VAH
- dirty conditions
3 % (30 ml/l)15 min.
bactericidal
EN13727, EN14561, in accordance with VAH
- dirty conditions
1.5 % (15 ml/l)60 min.
mycobactericidal
EN14348, EN14563, in accordance with VAH
- dirty conditions
3 % (30 ml/l)15 min.
mycobactericidal
EN14348, EN14563, in accordance with VAH
- dirty conditions
1.5 % (15 ml/l)60 min.
mycobactericidal
EN14348, EN14563, in accordance with VAH
- dirty conditions
2 % (20 ml/l)30 min.
yeasticidal
EN13624, EN14562, in accordance with VAH
- dirty conditions
2 % (20 ml/l)30 min.
yeasticidal
EN13624, EN14562, in accordance with VAH
- dirty conditions
3 % (30 ml/l)15 min.
yeasticidal
EN13624, EN14562, in accordance with VAH
- dirty conditions
1.5 % (15 ml/l)60 min.
virucidal against enveloped viruses
EN14476, EN17111
- dirty conditions
1 % (10 ml/l)10 min.
virucidal against enveloped viruses
in accordance with DVV (German Registered Association for Combating Viral Diseases
1 % (10 ml/l)10 min.
Adenovirus
in accordance with DVV (German Registered Association for Combating Viral Diseases
4 % (40 ml/l)60 min.
Polyoma SV40
in accordance with DVV (German Registered Association for Combating Viral Diseases
4 % (40 ml/l)60 min.
Rotavirus
EN14476
- dirty conditions
2 % (20 ml/l)60 min.
Application areaConcentrationContact time
in ultrasonic bath
3 % (30 ml/l)5 min.

Certificates

  • IHO listed
  • VAH certificate

Product data

Composition:
100 g solution contains the following active substances: 15.6 g Cocospropylene diamineguanidine diacetate, 35 g Phenoxypropanols, 2.5 g Benzalkoniumchloride.


Chemical-physical data

Density:ca. 0,99 g/cm3 / 20 °C
Form:liquid
Color:green
Flash point:40,5 °C / Method : ISO 3679
Viscosity, dynamic:ca. 30 mPa*s / 20 °C / Method : DIN 54453
pH:9,1 - 9,5 / 100 % / 20 °C

Special advice

Always read the label and product information before use. For professional use only. Any serious incidents related to the product are to be reported to the manufacturer and competent authority. If stock solutions and concentrates of gigasept® instru AF come into contact with other products (especially ones containing aldehyde), precipitations/ discolouration/ losses of efficacy are possible. Therefore, any mixture with other products is to be avoided. We therefore recommend rinsing all application aids and tubs thoroughly before using gigasept® instru AF for the first time.

Keep container tightly closed. Protect from frost, heat and sunlight. Store in the original container. Do not use gigasept® instru AF after the expiry date.

Information for order

ItemDelivery formItem no.
gigasept instru AF 2 l FL5/Cartonon request
gigasept instru AF 5 l KA1/Canisteron request
These products are not available in every country. For more information please contact our local subsidiary or distributor.

Environmental information

schülke manufactures products economically and with advanced, safe and environmentally friendly production processes while at the same time maintaining out high quality standards.
CE 0297

Privacy Policy

We use analysis methods (e. g. cookies) to measure how often our site is visited and how it is used. In addition, we use cookies to link your page visits and website use with your customer data stored in our CRM in order to be able to address you individually, i.e. based on interests and usage. We embed third-party content from other providers (e. g. videos) on our site. We have no influence on further data processing and any tracking by the third party provider.
In this context, we also use service providers in third countries outside the EU that do not have an adequate level of data protection, which harbors the following risks: Access by authorities without informing the data subject, no data subject rights, no legal remedies, loss of control.
With your settings you consent to the processes described above. You can revoke your consent with effect for the future. You can find more information in our privacy policy.