perform^®

Composition:
100 g powder contains the following active substances: 45 g Pentapotassium-bis-(peroxymonosulphate) bis(sulphate)
Labelling according to Regulation (EC) No. 648/2004:
5 - 15 % anionic surfactants; < 5 % non-ionic surfactants; < 5 % soap and phosphonates, perfumes

Chemical-physical data

Use disinfectants safely. Always read the label and product information before use.
The working solution may have a bleaching effect on certain very sensitive textile dyestuffs. Wearing protective gloves is advised. Store the container tightly closed and dry. For further information on safe handling and storage conditions, please refer to the safety data sheet. The shelf-life of the opened container can be found on the packaging. Ensure adequate ventilation at the site of application. Do not store bags or boxes above room temperature.

Application areas

perform® is suitable for disinfecting surfaces and medical devices. As a very well established product with a broad spectrum of activity and high material compatibility, it is used in all hospital areas. perform is also suitable for disinfecting respiratory and inhalation masks as well as training dummies.

Instructions for use

To prepare the working solution, fill the bucket with water, add the product and dissolve. When using the box, the corresponding dosing is carried out according to the dosing table or the box label:

- 1 bag (­40 g) to 8 l of water = 0.5% solution
- 2 bags (­80 g) to 8 l of water = 1% solution

The prepared working solutions have a lifetime of max. 30 hours (at 20°C) and 4 hours (at 40°C) for guaranteed stability of the active ingredient. The working solution should be replaced earlier in case of heavy contamination. Apply the working solution in the desired concentration to the floor using the 2-step wiping procedure. Wet wipe medical devices and other surfaces. To avoid formation of residues, only minimal residual moisture should remain on the surface after the second wiping step. In the case of immersion disinfection, rinse the products off with water after the exposure time. Because of its good material compatibility, perform® can also be used on sensitive surfaces such as PMMA. Ensure that all visible dirt is removed before disinfection. Clean equipment thoroughly with water. For professional use only. Any serious incidents related to the product are to be reported to the manufacturer and competent authority.

schülke manufactures products economically and with advanced, safe and environmentally friendly production processes while at the same time maintaining our high quality standards.